Inorganic arsenic is a regulated carcinogen in California, and the standard that governs it, Title 8 §5214, is one of the more prescriptive exposure rules in the General Industry Safety Orders. It sets an exposure limit, an action level, a monitoring schedule tied to results, regulated areas, a written compliance program with a six-month update cycle, respirator selection rules, hygiene facilities, medical surveillance on a fixed schedule, and 40-year record retention. This post walks through §5214 in the order an employer usually meets it.
Scope and What Counts as Inorganic Arsenic
Section 5214 sits in Article 110, Regulated Carcinogens, and under §5214(a) applies to the manufacture, use, storage, handling and disposal of inorganic arsenic. The scope paragraph carves out certain registered pesticide and ant-control uses, use of arsenically preserved wood, encapsulated electronic components, and intact sealed containers, though sealed containers still carry obligations for notification, spill cleanup, and signs and labels.
Under §5214(b), inorganic arsenic means elemental arsenic and all of its inorganic compounds, including copper acetoarsenite (Paris Green), with the exception of arsine. Materials containing 0.02 percent or less inorganic arsenic by weight are excluded from the definition. In the exposure assessments I perform, confirming whether a raw material or waste stream falls above or below that 0.02 percent line is often the first question to settle.
The PEL and the Action Level
Section 5214(c) sets the permissible exposure limit at 0.01 mg/m³ (10 µg/m³) of airborne inorganic arsenic as an 8-hour time-weighted average. Section 5214(b) defines the action level as 0.005 mg/m³ (5 µg/m³), also as an 8-hour TWA. Medical surveillance and training count exposure above the action level without regard to respirator use.
The action level is the trigger that matters most for planning. An employer whose results fall between 5 and 10 µg/m³ complies with the PEL and still carries most of the standard’s program obligations.
Exposure Monitoring: Schedule Set by Results
Section 5214(e)(1) requires full-shift personal samples, covering at least 7 continuous hours, with at least one sample per shift for each job classification in each work area. Section 5214(e)(2) requires initial monitoring of each workplace and work operation where exposure may occur. After that, §5214(e)(3) sets the repeat schedule:
- Above the PEL: repeat at least quarterly, under §5214(e)(3)(A), until two consecutive measurements taken at least seven days apart are at or below the PEL.
- At or above the action level but at or below the PEL: repeat at least every six months, under §5214(e)(3)(B), until two consecutive measurements at least seven days apart fall below the action level.
- Below the action level on initial monitoring, confirmed by two consecutive measurements: no further routine monitoring, under §5214(e)(3)(C), except as §5214(e)(4) requires.
Section 5214(e)(4) requires new monitoring within 30 days after any personnel, production, process, control or other change that may result in new or additional exposure. Under §5214(e)(5), employees must be notified of their results in writing within five working days of the employer receiving them, and where the PEL was exceeded the notice must say so and describe the corrective action being taken. Under §5214(e)(6), the sampling and analytical method must be accurate to within plus or minus 25 percent at or above the PEL and plus or minus 35 percent between the action level and the PEL, at a 95 percent confidence level. Section 5214(p) allows employees or their representatives to observe monitoring.
Regulated Areas and the Written Compliance Program
Under §5214(f)(1), regulated areas must be established wherever exposures exceed the PEL, regardless of respirator use. They must be demarcated and segregated from the rest of the workplace under §5214(f)(2), and access must be restricted to authorized persons under §5214(f)(3). Section 5214(f)(4) requires that all persons entering a regulated area be provided a respirator selected under §5214(h). Section 5214(k)(2) prohibits eating, drinking, tobacco use and cosmetics in regulated areas, although drinking fountains are permitted. Section 5214(l)(2) prescribes the sign legend, which includes “DANGER,” “INORGANIC ARSENIC,” “MAY CAUSE CANCER,” “WEAR RESPIRATORY PROTECTION IN THIS AREA” and “AUTHORIZED PERSONNEL ONLY.”
Section 5214(g)(1) requires exposure to be reduced to or below the PEL solely by engineering and work practice controls, except to the extent those controls are not feasible. A note to that subsection states that employee rotation or other administrative controls are not required before respirators are used. Section 5214(g)(2)(A) requires a written program to reach the PEL through those controls, with the contents listed in §5214(g)(2)(B), items 1 through 6, including a description of each operation, engineering plans and studies, technology considered, monitoring data and an implementation schedule. Under §5214(g)(2)(C) the plan must be revised and updated at least every six months, and §5214(g)(2)(D) requires it to be provided to the Chief on request and kept available at the workplace. In the programs I review, I check the date of the last six-month update first.
Respirators, Protective Clothing and Hygiene
Section 5214(h)(1) requires respirators during installation of feasible controls, where controls are not feasible, where controls are not yet sufficient, and in emergencies. Under §5214(h)(2)(A), the respirator program must meet §5144. Section 5214(h)(2)(B) requires that an employee who has difficulty breathing during fit testing or respirator use be examined by a physician trained in pulmonary medicine. Under §5214(h)(3), the employer must provide a powered air-purifying respirator in place of the selected respirator when an employee chooses one and it will provide adequate protection, and must provide HEPA filters for powered and non-powered air-purifying respirators.
Section 5214(i)(1) requires protective clothing and equipment, at no cost, for workers in regulated areas and wherever skin or eye irritation from inorganic arsenic is possible. Under §5214(i)(2), clothing must be provided freshly laundered at least weekly, and daily where exposures exceed 0.1 mg/m³. Section 5214(k)(1) requires employees to wash hands and face before eating and to shower at the end of the shift, §5214(k)(3) requires change rooms and showers, and §5214(k)(4) requires lunchrooms with a temperature-controlled, positive-pressure, filtered air supply. Section 5214(j) prohibits compressed air for cleaning and requires a written housekeeping and maintenance plan.
Medical Surveillance in the Standard’s Own Terms
Section 5214(n)(1)(A) covers employees who are or will be exposed above the action level, without regard to respirator use, at least 30 days per year, and former-exposure employees who were exposed above the action level for 30 days or more per year for a total of 10 years or more. Under §5214(n)(1)(B), the employer must obtain the services of a licensed physician, and §5214(n)(1)(C) requires all examinations and procedures to be provided without cost to the employee, without loss of pay, and at a reasonable time and place.
The initial examination under §5214(n)(2) includes a work and comprehensive medical history including smoking history, a physical examination of the systems the subsection lists, a posterior-anterior chest X-ray (14 by 17 inches), a sputum cytology examination, and other examinations the physician believes appropriate. Periodic examinations under §5214(n)(3)(A) and (B) are annual for employees under 45 with fewer than 10 years of exposure, and semi-annual, including sputum cytology, for employees 45 or older or with 10 or more years of exposure. Section 5214(n)(3)(C) requires a termination examination if none was given in the six months before employment ends.
Under §5214(n)(5), the physician’s written report interprets the results insofar as they concern occupational hazards, may not reveal specific findings or diagnoses unrelated to occupational exposure, must state that the employee has been informed of the results, and must be provided to the employee. The employer’s role is to arrange the examinations and supply the information listed in §5214(n)(6), including a copy of the standard and a description of the employee’s duties as they relate to exposure.
Training and Recordkeeping
Section 5214(m)(1) requires training for all employees who may be exposed above the action level, without regard to respirator use, or for whom skin or eye irritation is possible. Under §5214(m)(1)(A) it is provided at initial assignment and at least annually thereafter, covering the content items in §5214(m)(1)(B), including the hazards, work practices, respirator and protective equipment use, the medical surveillance program and a review of the standard. Section 5214(m)(2) requires the standard to be available to employees. Under §5214(o), exposure monitoring records, physician reports and medical records must be kept for at least 40 years or the duration of employment plus 20 years, whichever is longer.
What to Do This Week
- Confirm whether any material in your process contains more than 0.02 percent inorganic arsenic by weight.
- Check that your monitoring results are current for the schedule in §5214(e)(3), and that each employee received written notice within five working days.
- Pull your written compliance program and confirm it was updated within the last six months.
- List every employee above the action level for 30 or more days per year and verify their examination dates against §5214(n)(3).
- Confirm training records show initial and annual training for each covered employee.
If you need arsenic exposure monitoring or a review of your §5214 program, request a consultation through my industrial hygiene service or the recordkeeping and medical surveillance page, or call (626) 546-9384.