How to Petition the Cal/OSHA Standards Board

By Michael Karl McNeil, REP, RIH, EPP, QSD

Most employers deal with Title 8 as something that happens to them: a standard is adopted, the effective date arrives, and the job is to comply. California law also gives employers, workers, unions, trade groups and safety professionals a direct way to ask for a standard to be written, changed or repealed. The request goes to the Occupational Safety and Health Standards Board, the body the Labor Code makes responsible for adopting occupational safety and health standards, and the core rule is short. This post explains who can petition, what a petition should contain, how the Board handles it, the timeline the statute sets, and what follows a decision.

The Statutory Basis: Labor Code §142.2

The petition right comes from Labor Code §142.2. At each of its meetings, the Board must make time available to interested persons to propose new or revised orders or standards, or other items concerning occupational safety and health. The Board must consider those proposals and report its decision no later than six months after receiving them.

Two other Labor Code sections frame what the Board can do with a petition once it decides to act:

  • Labor Code §142.3(a)(1) makes the Board the only agency in the state authorized to adopt occupational safety and health standards, and it can adopt, amend or repeal a standard only by an affirmative vote of at least four members.
  • Labor Code §142.3(a)(2) requires the Board to adopt standards at least as effective as federal standards adopted under Section 6 of the federal Occupational Safety and Health Act. A petition asking California to go below a federal standard runs into that floor.
  • Labor Code §142.4(a) provides that standards are adopted, amended or repealed under the Administrative Procedure Act (Chapter 3.5 of Part 1 of Division 3 of Title 2 of the Government Code), except as modified by the Labor Code chapter.

On the Title 8 side, the Board’s procedural rules in Chapter 3.5 of Division 1 are written for variances, beginning with the application requirements in 8 CCR §411. I did not find a separate Title 8 article prescribing the form of a standards petition. The petition process rests on §142.2 and on the procedure the Board publishes for petitioners.

Who Can Petition

Section 142.2 uses the phrase “interested persons.” The Board’s published petition procedure describes the right broadly: any person may address the Board on occupational safety or health matters and may propose new or revised standards. There is no membership, licensing or standing requirement in the statute. An individual worker, an employer, a labor organization, an industry association or a consultant can each file.

The general Administrative Procedure Act petition provision, Government Code §11340.6, also allows any interested person to petition a state agency to adopt, amend or repeal a regulation, except where the right to petition is limited to a designated group or the form of procedure is otherwise prescribed by statute. For the Standards Board, §142.2 is the statute that sets the specific procedure, including the six-month decision period.

What a Petition Should Contain

The Board does not require a particular form. Its published procedure says a proposal may be made orally at a public meeting or in writing at any time, and oral proposers are asked to follow up in writing. The written proposal should state:

  1. The substance or nature of the standard requested, including any amendment or repeal.
  2. The reason for the request.

The Board asks petitioners to include supporting documents such as technical or engineering studies if they are available. Government Code §11340.6 lists the same two items and adds a third, a reference to the agency’s authority to take the requested action. Including that reference is good practice even though §142.2 does not spell out petition contents.

The Board’s guidance also points petitioners to the criteria the Office of Administrative Law applies when it reviews a regulation: necessity supported by substantial evidence, authority, clarity, consistency, reference and nonduplication. A petition that already answers those questions gives Board staff and the Division more to work with. When I evaluate whether a standard has a real gap, the most useful material is the evidence of the hazard and of the gap in the existing text: exposure data, incident patterns described without identifying anyone, and a precise citation to the subsection that falls short.

In practical terms, a strong petition identifies the exact Title 8 section and subsection at issue, proposes specific language rather than a general wish, explains who is affected and how, and addresses feasibility and cost honestly. A request that the Board “do something about” a hazard is harder to act on than one that offers redline text.

How the Board Handles a Petition

According to the Board’s published procedure, a petition can be presented at a Board public meeting or submitted in writing by mail or by email to oshsb@dir.ca.gov. Once received, the process runs as follows:

  1. The Board assigns the petition a file number.
  2. Board staff and the Division of Occupational Safety and Health each evaluate it.
  3. Board staff prepare a proposed decision for a Board business meeting.
  4. The Board grants or denies the petition, in whole or in part, and reports its decision within the six months §142.2 allows.

The Division’s evaluation matters. It reflects the enforcement agency’s view of whether the existing standard is working, whether the proposed language is enforceable, and whether the hazard is already addressed elsewhere in Title 8. Petitioners who anticipate those points in the original filing are in a better position at the business meeting. The Board posts its petition decisions on its website, and reading past decisions on similar subjects is a useful way to see how staff and the Division have analyzed comparable requests.

What Happens After a Decision

A grant does not adopt a standard. The Board’s procedure notes that petitions are often granted to the extent that an advisory committee of labor, management and knowledgeable persons is convened to review the proposal. The committee helps develop the proposed standard before it is scheduled for public hearing, or it may recommend that the Board not develop one.

If a proposal moves forward, it goes through rulemaking under the Administrative Procedure Act as Labor Code §142.4(a) provides, including public notice and hearing, and it can be adopted only by the four-member vote §142.3(a)(1) requires. That process takes time. A petition is the start of a rulemaking, not a shortcut around it.

A denial is not necessarily the end either. Read the reasons the Board gives in its decision; they can shape a stronger later request or a comment during a related rulemaking.

A Petition Is Not a Variance

A petition asks the Board to change the standard for everyone it covers. A variance leaves the standard in place and lets one employer use an alternative method at specified locations, on a showing that the alternative protects employees at least as well as the standard. Under 8 CCR §411, a permanent variance starts with a written application signed under penalty of perjury that identifies the specific regulation and subsections, describes the alternative practices, and shows equivalent protection, followed by notice to employees and a hearing. If your problem is that a standard does not fit your particular operation, a variance may be the right tool; if the problem is the standard itself, a petition is. I cover the variance process in more detail in Cal/OSHA permanent and temporary variances.

Neither a pending petition nor a pending variance application excuses compliance with the current standard. Until the text changes or a variance is granted, citations are issued against the standard as written, and the usual Cal/OSHA citation and appeal rules apply.

What to Do This Week

  1. Write down the exact Title 8 section and subsection you want changed and the specific problem with its current text.
  2. Gather the evidence you already have: exposure data, technical studies, equipment specifications or incident information with identifying details removed.
  3. Draft proposed language, not just a description of the change.
  4. Read the Board’s petition decisions on related subjects to see how similar requests were evaluated.
  5. Decide whether the issue is the standard itself (petition) or your operation’s fit with it (variance).

If you are considering a petition to the Standards Board and want the technical basis assembled and cited against the current text, I prepare that kind of evidence through my industrial hygiene services. Request a consultation or call (626) 546-9384.

Need help with a Cal/OSHA matter?

McNeil Safety Consulting provides Cal/OSHA citation defense, industrial hygiene, safety plan writing, and expert witness services throughout California. Call (626) 546-9384 or request a consultation.